Useful Tips for How to Replace a Cutlass Bearing

The bearing found on a vessel’s drive shaft log that is made with brass and a rubber lining that is grooved from the inside and which is lubricated by the water around that enters the grooves on rotation is what is termed as cutlass bearing, this.

After some time you must change the cutlass bearing regardless of how often you use your boat. When the time is up for changing the cutlass bearing, you will locate it a little off the keel or underneath the woodwork of the boat.

Apart from getting your hands dirty, you will not face any challenges when removing the cutlass bearing. These are the steps to follow to replace your boat’s cutlass bearing, now.

Locating and removing the set screws should be the first thing to do. In most cases, the screws are found hidden under a thin marine layer of crud and growth. Not all boat manufacturers use the set screws. If you already know that your boat does not have set screws, then it is not good to waste time looking for them.

During a cutlass bearing replacement you will be required to cut the bearing. In the absence of a Sawzall, you can use a hacksaw to cut the cutlass bearing. Using the Sawzall tool is something that requires you to have enough experience on how to use it.

Bending the cutlass bearing is the next step. You can bend the cutlass bearing to the inner side using a cold chisel and a hammer so that you reach the other side where you have made a cut. Do not use excessive force when hitting the cutlass bearing for it to bend. When you forcefully bend the cutlass bearing, you risk damaging the strut of the boat.

Insert a maple dowel after creating a space from bending the cutlass bearing on the boat to the inside and using a hammer slit it open to the other end. To open the cutlass bearing, avoid using any metal tools. By so doing you may damage the strut’s inside.

Lastly, you can now remove the cutlass bearing. Use a pair of pliers to hold the cutlass bearing to remove it. Now clean the surface of the strut and install a new cutlass bearing. After removing the old cutlass bearing, and the surface of the strut is clean, and you are about to install a new cutlass bearing bought from Propeller Depot ensure the cutlass bearing can enter the acme props in a straight line.

If the ramrod strut is forced and not straight it, you may damage it. To ensure it goes in straight, apply some grease so that the cutlass bearing washer’s can easily slide in the strut.